1
For the necklace: Thread beads onto beading wire, starting at the centre and working outwards.
Begin with a large (approx. 18mm) round pearl, add metal flower caps either side, then a crystal, followed by a metal cap, a smaller (approx. 13mm) pearl, another metal cap and a crystal.
2
Thread on a pink pearl, a pink round rondelle and another pink pearl, then a crystal. Add a turquoise pearl, a silver rondelle, another turquoise pearl and a crystal.
3
Slide on a metal cap a smaller (approx. 10mm) pearl and another metal cap, then a crystal. Repeat step 2.
4
Continue the pattern of a pink, white and then turquoise pearl followed by a crystal for the remainder of the necklace until you have reached your required length.
5
Finish off the ends, by threading on a silver crimp bead, then a jump ring. Pass the wire back down through the crimp bead before securing closed with flat nosed pliers. Push the raw end back into the beads to hide.
6
Attach another jump ring and a short length of silver chain to one end to create the extender chain. Attach a necklace clasp to the other end. To finish the extender chain, thread a silver bead and a crystal onto a head pin, bend the wire to 90°, cut 1cm away and make a loop to attach to the end of the chain.
7
For the earrings: Thread a head pin with a silver bead, a metal cap a (approx. 10cm) white pearl, another metal cap and another silver bead. Make a loop.
8
Create another head pin threaded with a pink pearl, a crystal and a silver bead, make a loop. Repeat to make a matching turquoise one.
9
Make a series of five joining jump rings to form a chain. Attach the white pearl head pin to the end, the pink pearl head pin to the middle jump ring and the turquoise pearl head pin to the top. Also attach a fish hook earring finding to the top jump ring.
10
Repeat to make a second matching earring.
11
For the bracelet: Thread the stretchy gossamer cord with pearls (as step 4 for the necklace). Tie the ends together in a double secure knot. Trim the ends of the cord and position the knot inside a bead to hide.
12
For the hanging tassel, repeat steps 1 and 2 (as for the earrings), Make a chain of three jump rings. Attach the largest white pearl head pin to the lowest jump ring, and the other two beaded pearl head pins to the top jump ring. Attach the top jump ring also around the bracelet to finish.