1
For the invitations etc - Cut 2cm strip of blue card. Trim so it is the same length of your card. Cut organza ribbon to measure approximately 6cm longer than the blue strip. Tie a knot in the centre and wrap lengthwise around the blue strip. Secure on the reverse with double sided tape. Use double sided tape to secure to the left of your card blank.
2
Cut a 5.5cm square of blue card, a 4.5cm square of white card, a 3.5cm square of blue card and a 2.5cm square of white card. Layer the square with the smallest on the top.
3
Now print your chosen words onto white vellum using a computer and printer. Trim into a strip and wrap around the layered squares, securing on reverse with double sided tape. Use 3D foam pads to stick at the top right corner of card.
4
Punch 3 hearts from matching blue card, adding a small adhesive pearl to each one. Use 3D foam pads to add the hearts in a row in the bottom right hand corner.
5
Print your inner on computer and adhere to centre of card with double sided tape
6
Ink all edges of card and envelope with pale blue ink pad, adding a punched heart to the outside of the envelope to finish
7
For the name place cards – Cut white card to measure 10cm by 10cm. Fold in half.
8
Print names onto vellum. Trim into strips and curl both ends around a wooden kebab skewer so they resemble scrolls. Use small pieces of double sided tape under the scroll ends to attach to the name card so that the adhesive is hidden.
9
Punch three hearts adding an adhesive pearl to each one. Group the hearts on the left hand side using 3D foam pads. Ink the edges to complete.
10
For the Favour Box - Trim blue card to measure 14cm by 6cm. Score this piece at 5.5cm from each end, leaving a 3cm gap in the centre. Fold to form the cover of the favour box as shown.
11
Take a 3 cm by 25 cm strip of white card and score every 5 cm, Fold into a square shape sticking the overlapping pieces together.
12
Stick one side of the square to the middle section of the box cover.
13
Make 3 1cm by 4cm white card tabs. Use double sided tape secure the 3 remaining sides to the inside bottom of box
14
Cut 30cm strip of ribbon, stick around the centre of the box cover leaving an equal amount at top and bottom to enable you to tie a bow closure.
15
To finish punch three blue hearts, adhering a small adhesive pearl to each. Layer on top of white punched hearts and use 3D foam pads to affix to the box lid.